2
Symbols
Caution symbol:
Indicates a potential risk. Failure to follow instructions may
result in serious injuries.
Note symbol:
Information, useful advice.
Refers to the relevant illustration in the introduction or main
text.
Safety instructions
General
• Installation, connection and initial operation of the drive mechanism may
only be carried out by qualified specialists.
• Only install the drive mechanism to correctly aligned and weight-
balanced doors. An incorrectly aligned door could cause serious injury or
damage to the drive mechanism.
• The manufacturer cannot be made liable for any damage or disruptions
to operation occurring due to non-compliance with the Installation and
Operating Instructions.
• Ensure that these Installation and Operating Instructions are located in
the garage in an easily accessible place.
• Observe and comply with the locally applicable accident prevention
regulations and EC standards.
• Observe and comply with the directive on 'Power-driven Windows, Doors
and Gates - BGR 232' issued by the Employers' Liability Insurance
Association (valid for the given user in Germany).
• Always disconnect the drive mechanism from the power supply before
carrying out any work.
• Only use the manufacturer's original spare parts, accessories and fixing
material.
Storage
• The drive mechanism may only be stored indoors, in a dry, sealed
environment at an ambient temperature of between -20°C and +50°C.
• The drive mechanism should be stored horizontally.
Operation
• The drive mechanism may only be operated after a risk-free force
tolerance has been set. Select the lowest possible force tolerance to
reduce the risk of injury.
• Keep your hands clear of any moving door or any moving parts.
• Keep children, disabled persons and animals away from the door.
• Only drive into and out of the garage when the door is fully opened.
• Risk of persons trapping or cutting themselves in/on the door system's
moving parts or edges where it closes.
• If the door is not equipped with a small door, or if there is no alternative
access to the garage, install an emergency release system (emergency
release lock or control cable) that can be activated from the outside.
(
1
)
1
Radio remote control
• The radio remote control may only be used for equipment and systems
in which defective remote operation of the transmitter or radio receiver
does not constitute a risk to people, animals or property, or in cases
where this risk is eliminated by means of additional safety facilities.
• The user must be made aware of the fact that the remote control of
equipment with accident risk potential may only occur, if at all, when the
equipment concerned is clearly visible.
• Radio remote control may only be used if movement of the door can be
supervised and there are no persons or objects in the area of movement.
• Store the manual remote control such that there is no risk of it being
accidentally operated by, for instance, children or animals.
• The operator of this radio-controlled equipment is in no way protected
from interference from other telecommunications systems and facilities
(e.g. other radio-controlled equipment that is licensed to operate at the
same frequency range). Should serious interference be encountered,
please contact your nearest telecommunications office with interference
measuring facilities (radio signal localisation)!
• Do not use the manually-operated remote control near locations or
installations that are susceptible to radio interference (airports,
hospitals).
Rating plate
The rating plate is located on the cover of the control unit housing.
Exact type designation and date of manufacture (month/year) of the drive
are to be found on the rating plate.
Normal use
Caution! Risk of serious damage to drive!
Do not open or close the door with the drive system without first
adjusting the balance weight (springs tensions). Otherwise, the
motor (gear system) might be seriously damaged.
Caution! Risk to life and limb!
Remove all ropes and loops that are required for the manual
operation of the door.
• The drive is designed for the exclusive purpose of opening and closing
doors. Any other use does not constitute normal use. The manufacturer
accepts no liability for damage resulting from use other than normal use.
The user accepts sole responsibility for any risk thereby incurred.
• Doors operating automatically with a drive must comply with the
standards and directives valid at the given time: e.g. EN 12604,
EN 12605.
• The drive system may only be operated if it is in proper working order.
Always follow standard safety procedures and adhere to the instructions
in this installation and operating manual.
• Any defects that may impair the safe operation of the equipment should
be eliminated without delay.
• The door leaves must be stable and twist-proof, i.e. they should not bend
or twist during opening or closing operations.
• The drive mechanism is unable to compensate for any defects in the
door or for its incorrect installation.
• Only use the drive mechanism in a dry, indoor environment where there
is no risk of explosion.
• Do not use drive in rooms where a hostile environment prevails
(e.g. salty air).
General Information
Commenti su questo manuale